Operating procedures

1. Unzip the zipper at the LOGO of the case body, press the extension part of the pull rod with your thumb, and pull the rod upward to the highest position.
2. Push the battery into the battery card slot in parallel (as shown in the figure).
3. Press the power switch and turn it on gently, and the blue light will turn on and show the breathing state(normal).
4. Press the handle controller switch, and the green light is on (breathing pattern) (as shown in the figure).
5. The toggle switch on the right side of the handle (as shown in the figure) is pushed forward as the forward start button and pushed backward as the electronic brake button.
6. The red light on the USB charging hole on the side of the handle flashes, indicating that the charge of the handle charger is insufficient. The charging state is always red.  (20 minutes).
7. The handle steering can be nearly 90 degrees. One foot on each side of the steering box needs to be pulled out manually.(as shown).
8. In the pull state, put away the direction control lever (the power     will be automatically cut off within 1 minute), pull up the upper zipper cover plate, pull out the rear hand pull lever and drag it (as shown in the figure).